Chip Tuning Seat Leon
Up to 30% more power for your Seat Leon
The Seat Leon (2005 →) is listed with 3 generations and 45 engines. For 35 turbo engines, choose the GAN GT or GAN GTL tuning module: the GAN GT adds +18 to +77 hp (GAN GT from 329 EUR, GAN GTL from 219 EUR). For 10 engines, choose the GAN GA or GAN GA+: the GAN GA+ adds +10 to +22 hp (GAN GA+ from 189 EUR).
Which Seat Leon do you have?
Start with the model year and chassis code. Within a generation, choose your engine by the power output in your vehicle documents.
Seat Leon tuning: what the GAN module does and doesn’t do
More power and torque without an ECU remap or replacing any parts. The tuning module only adjusts the engine sensor signals.
- Bluetoothsmartphone mode control
- 18 mappingsfine tuning for your engine

- 15 minutesfitted to the factory connectors
- IP67water and dust protection
- +77 hpwith the GAN GT on turbocharged engines
+18 to +77 hp across the Seat Leon range with the GAN GT or GAN GTL.
- +13 hpwith the GAN GA+ on naturally aspirated engines
Naturally aspirated Seat Leon engines: +10 to +13 hp.
- GAN APPpower control via smartphone
SPORT, DYNAMIC, ECO and STOCK modes in the GAN app.
- 50 daystest drive
Enhanced performance or your money back, excluding delivery costs.
Seat Leon chip tuning: engines and generations
Leon tuning: two 2.0 TDI 140 engines that look alike
SEAT Leon tuning with a tuning box is a lesson in engine codes: the Leon II 2.0 TDI with 140 hp exists as two different engines. The pump injector engines are the BKD with 16 valves, built from July 2005 to September 2011, and the BMM with 8 valves and a particulate filter. The BMM was built from October 2005 to October 2010. The common rail engine is the CFHC, built from May 2010 to October 2012.
The catalogue treats them separately, so the engine code decides which one applies to your car. The FR with 170 hp follows the same pattern, with the pump injector BMN until March 2009 and the common rail CEGA after it.
Cupra: one engine, four codes
The Leon III Cupra 265, 280, 290 and 300 are all the 2.0 TSI EA888 Gen3, with the codes CJXE, CJXA, CJXH and CJXC. The 265 and 280 date from March 2014, the 290 from November 2015 and the 300 from February 2017. Torque is 350 Nm in the 265, 280 and 290 and 380 Nm in the 300.
All four work with the GAN GT, each with its own figures in the catalogue. The Leon Cupra as a trim ended when Cupra became a brand in 2018. The sporty Leon IV is sold as the Cupra León, while the SEAT León IV continues in the ordinary range.
Other Leon engines
The 1.8 TSI with 160 hp, coded BZB or CDAA, is a first-generation EA888, on which higher oil use and chain tensioner faults can occur. The Leon III 1.4 TSI with 150 hp (ACT) switches off two cylinders under light load, and the 140 hp version has no ACT. The Leon is also written León, and its generations carry the codes 1M, 1P, 5F and KL.
Seat Leon chip tuning: questions
How do I tell the Leon II 2.0 TDI 140 with pump injectors from the common rail one, and how much more power does each get?
Go by the engine code, not the power figure, because both have 140 hp. BKD and BMM are pump injector engines and CFHC is common rail. In the catalogue the pump injector 2.0 TDI with 140 hp and 320 Nm reaches 157 hp and 358 Nm with the GAN GA+. The common rail version gets to 178 hp and 404 Nm with the GAN GT. These are the stated gains for these engine types, not dyno readings of your car.
Which module fits the Leon Cupra 265, 280, 290 and 300?
All four are the 2.0 TSI EA888 Gen3 and work with the GAN GT, so choose by the power and the code on your car.
How much power does the GAN GT add to the Leon II 1.8 TSI?
The catalogue takes the 1.8 TSI with 160 hp and 250 Nm to 206 hp and 325 Nm with the GAN GT.
Is a tuning module the same as a Stage 1 tune?
Not quite. Stage 1 usually means an ECU remap without replacing any parts. The tuning module also works without replacing parts, but it does not change the ECU software: it adjusts the sensor signals, comes off in about a minute, and the OFF button in the app restores the factory settings.