Chip Tuning Ford Focus
Up to 30% more power for your Ford Focus
The Ford Focus is listed with 5 generations and 66 engines. For 41 turbo engines, choose the GAN GT or GAN GTL tuning module: the GAN GT adds +20 to +77 hp (GAN GT from 329 EUR, GAN GTL from 219 EUR). For 25 engines, choose the GAN GA or GAN GA+: the GAN GA+ adds +9 to +26 hp (GAN GA+ from 189 EUR).
Which Ford Focus do you have?
Start with the model year and chassis code. Within a generation, choose your engine by the power output in your vehicle documents.
Ford Focus tuning: what the GAN module does and doesn’t do
More power and torque without an ECU remap or replacing any parts. The tuning module only adjusts the engine sensor signals.
- Bluetoothsmartphone mode control
- 18 mappingsfine tuning for your engine

- 15 minutesfitted to the factory connectors
- IP67water and dust protection
- +77 hpwith the GAN GT on turbocharged engines
+20 to +77 hp across the Ford Focus range with the GAN GT or GAN GTL.
- +21 hpwith the GAN GA+ on naturally aspirated engines
Naturally aspirated Ford Focus engines: +9 to +21 hp.
- GAN APPpower control via smartphone
SPORT, DYNAMIC, ECO and STOCK modes in the GAN app.
- 50 daystest drive
Enhanced performance or your money back, excluding delivery costs.
Ford Focus chip tuning: engines and generations
Ford Focus tuning: the same 125 hp, two different modules
The Mk3 is a good place to begin Ford Focus tuning with a tuning box, because it offers 125 hp twice: as the naturally aspirated 1.6 Ti-VCT and as the turbocharged 1.0 EcoBoost. The Ti-VCT makes 159 Nm and works with the GAN GA+, while the three-cylinder EcoBoost makes 170 Nm and is matched to the GAN GT. For Ford Focus chip tuning the Mk number matters, because the generations are called by it. The Mk1 ran from 1998 to 2004, the Mk2 from 2004 to 2011, the Mk3 from 2011 to 2018, and the Mk4 started in 2018.
Four generations, four sets of engines
The Mk1 had Zetec petrol engines from 75 to 130 hp and the 1.8 TDCi with 100 and 115 hp, with the ST170 and the 215 hp RS at the top. Focus Mk2 tuning covers the 1.6, 1.8 and 2.0 TDCi diesels, the Duratec petrol engines up to 145 hp and the ST with a 2.5 turbo and 225 hp. The Mk2 facelift arrived in February 2008, and the RS500 of May 2010 was limited to 500 cars with 350 hp. The Mk3 was built at Saarlouis from December 2010, and its facelift was shown in February 2014.
The Mk3 petrol range is mostly turbocharged: the 1.0 EcoBoost, the 1.6 EcoBoost until September 2014 and then the 1.5 EcoBoost with 150 and 182 hp. The Mk4 has the 1.0 and 1.5 EcoBoost and the EcoBlue diesels. The 1.6 EcoBoost with 150 and 182 hp had a recall for coolant level monitoring on cars built between July 2010 and September 2014.
Ford Focus chip tuning: questions
What does the GAN GT add to the Focus Mk3 1.0 EcoBoost?
With the GAN GT the Mk3 goes from 125 hp and 170 Nm to 162 hp and 230 Nm. The 100 hp car is listed separately. These are the stated gains for this engine type, not a dyno reading of your car.
Is Ford Focus 1.6 TDCi tuning the same for the Mk2 and the Mk3?
No. The Mk2 has the 1.6 TDCi with 90 and 109 hp, the Mk3 its own versions with 95 to 116 hp, so each is covered separately, both with the GAN GT. So for Ford Focus Mk2 1.6 TDCi tuning, go by the hp figure of your car.
Focus ST Mk2: Mountune kit or tuning box?
Ford and Mountune sold a dealer kit in 2008: a larger intercooler, an air filter and a recalibration, taking the ST from 225 hp and 320 Nm to 260 hp and 400 Nm. A tuning box adds no hardware; it adjusts sensor signals, and the ST 2.5 works with the GAN GT.
Tuning box or ECU remap on a Focus?
Unlike an ECU remap, which rewrites the factory software, a tuning box sits between the engine sensors and the ECU and adjusts their signals. With the GAN module the factory software, checksums and flash counter stay untouched, and the engine's factory protections remain active. Your manufacturer's warranty is preserved: the ECU software is never changed, and the module can be removed at any time.
Is a tuning module the same as a Stage 1 tune?
Not quite. Stage 1 usually means an ECU remap without replacing any parts. The tuning module also works without replacing parts, but it does not change the ECU software: it adjusts the sensor signals, comes off in about a minute, and the OFF button in the app restores the factory settings.